AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Cable shroud meaning8/26/2023 Note: To meet the minimum requirement as listed in IP54, threaded cable entry device into threaded cable entry plate or enclosures with the thickness of 6 mm or more do not need additional sealing between the cable entry device or the entry plate or the enclosure if the axis of the cable entry device is exactly perpendicular to the outer surface of the cable entry plate or enclosure. Their entry point should be marked with the signage in accordance with Section 2, Article 7 of the ATEX Directive. Documents need to be place regarding explosion protection in places where possible highly explosive atmosphere may appear which may endanger the health and safety of the workers.General commitments regarding safety and health of the worker.Assessment of commitments regarding the assessment of risks of explosion.Commitments to the employees regarding prevention and protection against explosions.This ATEX Directive is focussed to cover the usage of devices in possible explosive atmosphere and it is aimed at providing minimal requirements that upgrade the safety standards and improve the health of the workers.Īrticle 137 of Directive 89/391/EC was published in the official journal of the EC on 28th January 2000 as Directive 99/92/EC, being the 15th individual Directive of the framework Directive 89/391/EEC. Internal Production Control – The manufacturer should verify that the product design and each production device should comply with either harmonized European Standards or the fundamental needs or a combination of the two.Product Verification – Every product item is inspected and/or tested for orderliness as per the EU Type Examination.Assured Production Quality – that includes the assessment, sporadic auditing, testing and inspection of relevant product samples as per the manufacturer’s quality policy.EU Type Examination – that includes testing and inspection of relevant design of devices.Orderliness assessment measures are inclusive of but are not limited by: The Notified Body needs to be approved and appointed by the concerned government. These procedures may need the involvement of the Notified Body which is separate from the manufacturer and is able to assess the orderliness of the devices and the manufacturer as per the Directive. The assuring process of devices adhering to the Directive, the orderliness assessment measure(s) must be complied with. EPL Electrical Apparatus Installations in Hazardous Area.Hazardous Zones, Substances & Categories.IEC Standards For Explosive Atmospheres.Earth Bars with Double Disconnecting Link.Earth Bars with Single Disconnecting Link.U Bolt For Rigid Pipe & Cable (Type ‘PUB’).
0 Comments
Read More
Leave a Reply. |